Instructions
HOW TO START YOUR INLAND WATCH
- Remove the plastic spacer between the case and crown
- Press the crown in the watch case
The second hand will begin to move in one-second intervals.
HOW TO SET TIME
- Pull the crown out to B position
- Turn the crown clockwise to adjust hour and minute
- Press the crown back to A position
Make sure the crown is completely pressed back to its initial position before and during contact with water to avoid any infiltration.
HOW TO SET SECOND TIME ZONE
- Pull Second Time Zone crown in B position
- Turn the crown anti-clockwise to adjust hour
- Press the crown back to A position
Set minutes of the second time zone close to minutes of the Main Time Zone and it will set automatically
Make sure the crown is completely pressed back to its initial position before and during contact with water to avoid any infiltration
HOW TO CHANGE STRAP
Remove a Classic strap Model and put back another Classic strap model
- Hold your watch face down on a clean cloth
- Use your Maison Inland tool
- Insert tool between the lug and strap to reach the metal spring bar
- Press in the spring bar and push down to remove the strap
- Remove the spring bar from the strap hole to insert it in the new strap
- Place a pin end in a lug hole
- Use the tool to press the spring bar in the strap
- Push down the spring bar inside the lug to lock it inside the other pin hole
Remove a Classic strap model and put back a Belt strap model
- Hold your watch face down on a clean cloth
- Use your Maison Inland tool
- Insert tool between the lug and strap to reach the metal spring bar
- Press in the spring bar and push it down to remove the strap
- Remove the spring bar from the strap hole
- Place a pin end in a lug hole
- Use the tool to press the spring bar
- Push down the spring bar inside the lug to lock it inside the other pin hole
- Insert the Belt strap between the spring bar and the watch head starting from the top of the watch
Insert the strap perpendicularly to the watch case, to avoid friction with the case edges
Remove a Belt strap model
- Hold your watch face down on a clean cloth
- Pull the strap between the spring bar and the watch case
Pull on the strap perpendicularly to the watch case, to avoid friction with case edges
Put a Belt strap model
- Make sure both spring bars are installed on the watch head
- Insert the Belt strap between the spring bar and the watch head starting from the top of the watch
Insert the strap perpendicularly to the watch case, to avoid friction with the case edges
CHANGE YOUR STRAP BUCKLE
- Turn your strap face down
- Use your Maison Inland tool
- Insert the tool between the strap and the buckle to reach the spring bar
- Press in the spring bar and push it down to remove the strap
- Remove the spring bar from the strap hole
- Insert the buckle tongue in the new strap
- Insert the spring bar in the new strap hole, going through the buckle tongue
- Put a pin end on a the buckle hole
- Make sure the buckle tongue is on the top side of the buckle
- Use your tool to press in the spring bar
- Push down the spring bar inside the buckle to lock it inside the other pin hole
CHANGE BATTERY
All Inland watches are 100 meters water resistant, so the back case is screwed and sealed according to this standard.
In order to maintain its original level of water resistance, we recommend you to visit a jeweler familiar with such watches to change the battery.